I managed to model the trim piece well enough after a bit of mucking around. I was struggling to loft it as a surface and then make it a solid so in the end I just lofted it as a solid. That's probably not correct but at this stage I just needed to keep moving. The result is the same for all intents and purposes. I haven't yet put the flat spot on the back for the arm, I will need to do this before the arms can go on.
I couldn't find any instructions for how to make the nose bridge, although Dan did say they would be available. I made it simply by creating the front surface and using the thicken tool. The detail I made by using the curve tool to project a sketch onto the surface and then using a swept cut from the right plane to make the circular indent.
I have spent the last day stuck as my model decided to get confused by external references. I think I have finally figured out how to break the missing references and can finally continue modelling where I left off.
No comments:
Post a Comment